01. The parking or emergency brake on a heavy vehicle can only be held in position by something that cannot leak away, like:
a. fluid pressure.
b. spring pressure.
c. air pressure.
d. any of the above.
02. A straight truck or bus air brake system should not leak at a rate of more than ___ psi per minute with the engine off and the brakes released.
a. 1.
b. 2.
c. 3.
d. 4.
03. Your vehicle has a dual air brake system. If a low air pressure warning comes on for the secondary system, you should:
a. bring the vehicle to a safe stop and continue only when the system is fixed.
b. reduce your speed, and test the remaining system while under way.
c. reduce your speed, and drive to the nearest garage for repairs.
d. continue at normal speed if only the second system fails.
04. If your vehicle has an alcohol evaporator, it is there to:
a. rid the wet tank of alcohol that condenses and sits at the bottom.
b. eliminate the need for daily tank draining.
c. boost tank pressure the same way that superchargers boost engines.
d. reduce the risk of ice in air break valves in cold weather.
05. Air braking takes more time than hydraulic braking because air:
a. brakes use different brake drums.
b. takes more time to flow through the lines than hydraulic fluid.
c. brakes require heavier return springs.
d. is always leaking through air line fittings.
06. The brake pedal in an air brake system:
a. controls the speed of the air compressor.
b. always needs to be held down halfway during normal driving.
c. controls the air pressure applied to put on the brakes.
d. is connected to slack adjusters by a series of rods and linkages.
07. If your truck or bus has dual parking control valves, you can use pressure from a separate tank to:
a. release the spring emergency/parking brakes to move a short distance.
b. apply more brake pressure if the main tank is getting low.
c. stay parked twice as long with your service air pressure.
d. balance the service brake system whenever you are parked.
Page 1 answers: (1)b (2)b (3)a (4)d (5)b (6)c (7)a
Pages 
